PRV Audio’s ALTO Series were carefully crafted and voiced to reproduce a natural, smooth sound while remaining dynamic. To get the superior fidelity, a special composite cone is used to smooth frequency response and to keep the moving mass low, increasing the efficiency.
6.5″ PRO audio Midrange speaker designed for Low Frequencies with shallow profile
200 watts RMS program power gives capability of high acoustical output with small amplifier
Impressive choice for high output home, car, and professional audio systems – 8 Ohm Impedance
Smooth response through the mid-bass and vocal range at at loudest volumes
To ensure absolute signal fidelity, a cloth sealed surround is combined with a carefully crafted Kevlar-loaded paper cone. Additionally, a vented pole piece allows heat to escape for reduced power compression.
The 6MR200A midrange speaker is the evolution of the 6MR250A, this unit was designed with the goal of producing the highest possible output from a compact design without sacrificing performance, with only 2.24″ mounting depth.
This professional midrange speaker is purpose-built to cover from 100 Hz to 6,000 Hz in three-way speakers, but also works great as a midrange in a bass guitar speaker, as well as a woofer in two-way satellite speaker concept or even as a high output car audio door speaker.
Recommended Hi Pass Crossover* *For Full Power Handling
150 Hz** **12db Per Octave Crossover
Frequency Response at -10dB
155 – 11,000 Hz
Voice Coil Diameter
1.5″ (38 mm)
Voice Coil Wire
Copper
Voice Coil Winding Depth
8.0 mm
Former Material
Kapton
Magnetic Gap Depth
5.5 mm
Frame Material
Stamped Steel
*Nominal power handling is defined as the maximum RMS power that the speaker can handle in a 2-hour test with a pink noise with 6dB of crest factor and a bandpass filter with 12db/oct tuned in its usable frequency range. **Continuous Program Power (RMS) is the maximum power that the speaker can handle considering a regular musical program using our recommended filters, this power can be used to define the optimum amplifier power to avoid a clean signal without clipping or saturation. ***Max Peak Power is the maximum power operation for the speaker, this power is allowed just for a few fractions of a second, usually found just on the peaks of the music. Keeping this power for a little longer timer will damage the speaker.
THIELE-SMALL PARAMETERS
Equivalent Volume
Vas
3.16 l
Excursion (mathematical)***
Xmax
2.62 mm
Free Air Resonance
Fs
114.1 Hz
Mechanical Factor
Qms
13.16
Electrical Factor
Qes
1.28
Total Factor
Qts
1.17
Cone Area
Sd
137 cm²
Mechanical Mass
Mms
10.1 g
Bl Factor
Bl
6.27 Tm
Dc Resistance
Re
5.5 Ohms
Inductance
Le
0.26 mH at 1 kHz
Mechanical Mass Without Air
Mmd
9.02 g
Mechanical Compliance
Cms
0.120 mm/N
***Xmax=(Voice coil winding depth-Magnetic Gap depth)/2+ Mgnetic Gap Depth/4
I bought 6 of these MR200 speakers to get more vocals out paired with a stetsom 1600.1 1 ohm amp on a prv Dsp and it sounds amazing with the rest of my wife's set up in her Jeep and we was blown away. She has 8 8 inch prv MB500 for midbass with 4 8s inside the jeep in her sound bar, 4 prv 280ti drivers in her back stunt wall and 8 350ti-4 ohm tweeters in series Parallel bringing them down to 2 ohms for all 8 tweeters and the results is breathtaking. Awesome Job Dan and the rest of the PRV team. You guys Rock.
Twelve V Fever
I opted for the 6MR200A for a "budget" golf cart build and the speaker did not disappoint even though it is one of the more beginner speakers offered by PRV. We put 12 of them on the golf cart with 8x TW350Ti-4.
Twelve V Fever
I opted for the 6MR200A for a "budget" golf cart build and the speaker did not disappoint even though it is one of the more beginner speakers offered by PRV. We put 12 of them on the golf cart with 8x TW350Ti-4.
Twelve V Fever
I opted for the 6MR200A for a "budget" golf cart build and the speaker did not disappoint even though it is one of the more beginner speakers offered by PRV. We put 12 of them on the golf cart with 8x TW350Ti-4.
Caesarsoundz
PRV IS SLEPT ON!!! Any motorcycle I do installs to will have all prv audio! Sound is amazing and crystal clear!!
Tim Weiler
I can now crank up my music and have it come through crystal clear both instrumental and vocal wise.
Daniel Kosek
Sounds real,good
Daniel Kosek
Sounds real,good
1-10 of 48 reviews
George Ferrer JR
Awesome speakers for vocals
I bought 6 of these MR200 speakers to get more vocals out paired with a stetsom 1600.1 1 ohm amp on a prv Dsp and it sounds amazing with the rest of my wife’s set up in her Jeep and we was blown away. She has 8 8 inch prv MB500 for midbass with 4 8s inside the jeep in her sound bar, 4 prv 280ti drivers in her back stunt wall and 8 350ti-4 ohm tweeters in series Parallel bringing them down to 2 ohms for all 8 tweeters and the results is breathtaking. Awesome Job Dan and the rest of the PRV team. You guys Rock.
Twelve V Fever
Entry level price, advanced sound
I opted for the 6MR200A for a “budget” golf cart build and the speaker did not disappoint even though it is one of the more beginner speakers offered by PRV. We put 12 of them on the golf cart with 8x TW350Ti-4.
Ramon Ortiz
Great
Eliut Infante
Amazing speaker
I have not installed them yet but I know they are amazing. My cousin installs these speakers in all his cars. I had a problem with ordering 2 different size speakers with different ohms and the customer service was quick with a response and was able to help me with the problem. Shout out to the customer service.
jwvnz
6.5
they sound really good and clear !
Caesarsoundz
A good brand!!
PRV IS SLEPT ON!!! Any motorcycle I do installs to will have all prv audio! Sound is amazing and crystal clear!!
Tim Weiler
Awesome sound quality
I can now crank up my music and have it come through crystal clear both instrumental and vocal wise.
Cheeks
6MR200A-8
Speakers haven’t been installed as yet. Overall weight and construction of speaker seems to be of good quality, can’t wait to install and hear these things talk.
Bernard Leduc
verry good mid
that’s a verry good mid speaker in a three way configuration from 600 Hz to 6Khz, mid his clear with no coloration.
Très bon médium dans un système trois voies, 600 Hz à 6KHZ net et sans coloration
I bought 6 of these MR200 speakers to get more vocals out paired with a stetsom 1600.1 1 ohm amp on a prv Dsp and it sounds amazing with the rest of my wife’s set up in her Jeep and we was blown away. She has 8 8 inch prv MB500 for midbass with 4 8s inside the jeep in her sound bar, 4 prv 280ti drivers in her back stunt wall and 8 350ti-4 ohm tweeters in series Parallel bringing them down to 2 ohms for all 8 tweeters and the results is breathtaking. Awesome Job Dan and the rest of the PRV team. You guys Rock.
I opted for the 6MR200A for a “budget” golf cart build and the speaker did not disappoint even though it is one of the more beginner speakers offered by PRV. We put 12 of them on the golf cart with 8x TW350Ti-4.
Great
I have not installed them yet but I know they are amazing. My cousin installs these speakers in all his cars. I had a problem with ordering 2 different size speakers with different ohms and the customer service was quick with a response and was able to help me with the problem. Shout out to the customer service.
they sound really good and clear !
PRV IS SLEPT ON!!! Any motorcycle I do installs to will have all prv audio! Sound is amazing and crystal clear!!
I can now crank up my music and have it come through crystal clear both instrumental and vocal wise.
Speakers haven’t been installed as yet. Overall weight and construction of speaker seems to be of good quality, can’t wait to install and hear these things talk.
that’s a verry good mid speaker in a three way configuration from 600 Hz to 6Khz, mid his clear with no coloration.
Très bon médium dans un système trois voies, 600 Hz à 6KHZ net et sans coloration
Great sound