The lower Qts allows more precise midbass. Superior fidelity is achieved through a perfect combination of a non-pressed cone with a smooth frequency response and its well ventilated magnet motor specially designed to allow high displacement without increasing distortion.

• 2.5″ Voice Coil – More power handling and less distortion on mid low midbass frequencies
• Its powerful neodymium motor is vented to provide excellent cooling.
• 8″ PRO Audio Midbass loudspeaker designed for Low Frequencies at High Power – 8 Ohm
• 700 watts RMS program power gives capability of high acoustical output.
• Also Available at 4 Ohm

To get superior fidelity, the special composite cone is built with non-pressed paper for reduced break-up, delivering a smooth frequency response and a low moving mass, increasing the efficiency of the speaker.

This 8″ is a great midbass option for pro audio systems or high SPL automotive systems, where extremely high output is required.

This midbass will stand up to years of serious professional use! Thanks to its special composed spider reduces distortion at a high excursion and double roll surround keep cone travel linear at high excursion.

The 8MB700FT-NDY is an extremely efficient 8″ midbass, due to its wide frequency band and 98 dB sensitivity rating, this speaker is ideal for pairing with compression drivers, on 3-Way system.

The large 2.5″ voice coil allows for the high 700 watts power handling and warrants the outstanding cooling system implemented into the motor.

Engineered with 11 mm of winding depth, this inside/outside voice coil provides excellent thermal and mechanical durability.

PRV 8″ Midbass Speaker 8MB700FT-NDY 700 Watts / 8 Ohm High Power PRO Audio Low Frequency Neodymium Loudspeaker

Recommended Amplifier configurations and crossover points:
2 Speakers – 1x MDX1200.2 2 Ohm, 2 speakers in parallel on bridged channel
4 Speakers – 1x QS3000 2 Ohm, 4 speakers in parallel
8 Speakers – 1x QS5000 1 Ohm, 8 speakers in parallel

Recommended HPF using PRV Digital Signal Processor DSP when using up to 700 Watts RMS musical power ( without clipping )

• 95 Hz at 12 dB per octave filter Crossover / BT12
• 85 Hz at 18 dB per octave filter Crossover / BT18

If you have compression drivers on your system the recommended LPF is 4,500 at 18 dB per octave filter Crossover / BT18 but you may set it lower to blend in better depending on the other components in your system, or you may not use a LPF at low power to take advantage of its high frequency response.