There is no doubt that the 6MR500-NDY is one of the best midrange loudspeakers for audio professionals. It offers excellent durability and a smooth full-range response up to 13,000 Hz.

Combined with other fine materials, this high-energy, rare-earth neodymium motor magnet assembly resolves fine details in audio, which is a high-end requirement for audiophiles in car audio and motorcycle custom builders. Great addition to the MR Neodymium Series!

You can expect an excellent sound stage and realistic sound reproduction with this loudspeaker’s wide coverage and transient response. This refers to the ability to accurately reproduce rapid changes in sound, contributing to a high-quality audio experience.

• Great as door speaker for large custom door panel setup.
• Built for loud and clear vocal performance in tight, compact spaces
• 500 Watts RMS power rating produces high acoustic output
• 2″ DUAL layer CCAW voice coil wound on Kapton former, 8 Ohm
• Fast transient response, minimal tonal coloration, and a deep, dynamic midbass
• Also available in 4 Ohm – 6MR500-NDY-4

The powerful neodymium slug magnet assembly ensures high flux concentrations. Its magnetic structure significantly improves heat dissipation. This increases power handling and lowers power compression, with an optimal power-to-weight ratio.

Everything about this speaker is designed for reliable and consistent high output levels even when driven to its limit. This allows you to achieve high fidelity sound at low distortion with the most enjoyable possible listening experience.

PRV 6.5″ Midrange Speaker 6MR500-NDY 500 Watts / 8 Ohm – High Power Neodymium PRO Audio Loudspeaker

Recommended Amplifier configurations and crossover points:
2 Speakers – 1x MDX1200.2 2 Ohm, 2 speakers in parallel on bridged channel
4 Speakers – 1x QS3000 2 Ohm, 4 speakers in parallel
8 Speakers – 1x QS5000 1 Ohm, 8 speakers in parallel

Recommended HPF using PRV Digital Signal Processor DSP when using up to 500 Watts RMS musical power

• 220 Hz at 12 dB per octave filter Crossover / BT12
• 180 Hz at 18 dB per octave filter Crossover / BT18

If you have compression drivers on your system the recommended LPF is 5,000 at 18 dB per octave filter Crossover / BT18 but you may set it lower to blend in better depending on the other components in your system, or you may not use a LPF at low power to take advantage of its high frequency response.